Westcam Technologies » Production moulds » Engineering

Engineering

With more than 15 years of experience in tooth modelling WESTCAM helps to innovate tooth lines: renewal of the appearance of teeth as well as increasing of production capacities by improved mould design is possible.

The images below show a small selection of our engineering possibilities:

  • Digital reconstruction of missing areas  » Click to zoom ->

    Digital reconstruction of missing areas

  • Digital correction of surface defects  » Click to zoom ->

    Digital correction of surface defects

  • Intelligent flash removal  » Click to zoom ->

    Intelligent flash removal

  • Intelligent flash removal  » Click to zoom ->

    Intelligent flash removal

  • Dynamic correction of offset by keeping the original dimensions  » Click to zoom ->

    Dynamic correction of offset by keeping the original dimensions

  • Intensification of surface structures according to customer requests  » Click to zoom ->

    Intensification of surface structures according to customer requests

  • Texturizing of smooth tooth surface according to customer requests  » Click to zoom ->

    Texturizing of smooth tooth surface according to customer requests

  • Intelligent removal of undercuts, without change of overall appearance, to obtain a smooth production flow  » Click to zoom ->

    Intelligent removal of undercuts, without change of overall appearance, to obtain a smooth production flow

  • Rounding of sharp edges to improve appearance and quality  » Click to zoom ->

    Rounding of sharp edges to improve appearance and quality

  • CAD construction of a defined basal cavity to improve adhesiveness  » Click to zoom ->

    CAD construction of a defined basal cavity to improve adhesiveness

  • Layer construction corresponding to customer specific master layers  » Click to zoom ->

    Layer construction corresponding to customer specific master layers

  • Modelling of dental veneers based on existing full anatomic teeth  » Click to zoom ->

    Modelling of dental veneers based on existing full anatomic teeth

  • Modelling of layers of a dental veneer  » Click to zoom ->

    Modelling of layers of a dental veneer

  • Analysis of reshaped teeth  » Click to zoom ->

    Analysis of reshaped teeth

  • Analysis of a defined flash between two closed mould parts  » Click to zoom ->

    Analysis of a defined flash between two closed mould parts

  • Improvement of production capacities by at least 33% by intelligent dynamic placement of cavities  » Click to zoom ->

    Improvement of production capacities by at least 33% by intelligent dynamic placement of cavities

  • Construction of mould geometries based on customers needs  » Click to zoom ->

    Construction of mould geometries based on customers needs